ARMAMENT
The original arms carried by the EZ-036 Death Stinger have been replaced with more modern systems. In addition, the EZ-436 Tyrann Stinger carries heavy conventional weapons and defensive batteries. Also, the firing arcs have been greatly accentuated; no longer limited to the fore and aft arcs of its predicessor. The danger of the new Stinger is multifold.
Graviton Mortar (x2) – Dorsal mounted, forward arc, fixed
The enormous cannons mounted on the Tyrann Stinger condense graviton particles and surge them up to 4 kilometers away. The graviton bolt reacts to any dense matter in its path, causing an instability that sends the gravitons spraying in all direciont. The effect on the target is terrifying; it literally flies apart as each piece is forced to fall toward a different micro singularity. Worse, it takes a hell of a toll if fired through a herd of light units.
180mm Charged Particle Cannon – Tail mounted, horizontal arc via 180º elevation, 90º lateral arc
The original and still most effective weapon of its type, the Tyrann Stinger's CPC can fire repeatedly, and the tail affords it the ability to target a far wider arc of 90º. The CPC takes tremendous energy to use for any length of time and is limited to a range of only 5 kilometers, but it is a terrifying weapon.
70mm Particle Bolt Rifle (x2) – Rear nacelle mounted, forward arc, 180º rotation
Mounted on the rear claw housing, these guns gives the Tyrann Stingtinger 360º of armor piercing firepower Using a compressed particle stream that is super accelerated, a shot from the PBR will rip through a Gojulas' armor at 6 kilometers with 85% accuracy. The one disadvantage to these guns is the slow rate of fire; they require a full 30 seconds to cool and recharge between shots. An eternity on the battlefield, but the Stinger has other weapons.
50mm Linear Pulse Cannon (x2) – Tail mounted, horizontal arc via 180º elevation, 40º lateral arc
Mounted in armored pods on the tail, adjascent to the CPC, the linear pulse cannons are designed to be as effective at defense as offense. As a linear cannon the weapon is suiteable for attacking even heavy targets. In pulse mode the beam is released as a stream of weaker bursts; damage per beam is far less, but accuracy is much greater. This mode is suitable for striking faster, lighter foes, or to target incoming projectiles at a range of up to 4 kilometers.
30mm Linear Pulse Cannon (x2) – Tail mounted, horizontal arc via 180º elevation, 40º lateral arc
Identical architecture to the 50mm cannons, the smaller guns have a faster rate of fire in both modes, giving the Tyrann Stinger a horriffic spread of firepower. Range is limited to 3 kilometers but the cannons can fire almost without ceasing.
35mm Rapid Fire Defense Battery (x2) – Back mounted, 40º elevation, 180º lateral arc
Each of these twin-barrel guns is mounted atop a magazine of 2,000 round magazine that it can chew through at a rate of 20 pounds per second. These guns are turned on lighter targets as a secondary measure, or to defeat e-shield protected units.
50mm Hardlight Burst Cannon (x6) – Head & claw mounted, forward arc, fixed
Installed to augment the projectile firepower of the EZ-436, each cannon looses a burst of 12 shots in a half a second. Each magazine holds 40 bursts of hypervelocity APEX rounds that can tear up to 100 targets apart at up to 10 kilometers.
Hyper Alloy Claws (x4) – Arm mounted, forward arc, integrated construction
The claws of the Tyrann Stinger are solid, crushing and cutting nightmares. The forward claws can smash smaller Zoids effortlessly and grind even huge machines to twisted wrecks in moments. The rear claws are much smaller but can slice through armor and dismember enemies in short order.
Hyper Alloy Mandibles – Head mounted, forward arc, integrated construction
The bite of the ZE-436 Tyrann Stinger can scissor through most hardened armor, should an enemy get close enough. Combined with the Hyper Alloy claws, melee combat will usually end with mauled enemies in tatters.
Hyper Alloy Breaker Blades (x2) – Head mounted, forward arc, integrated construction, 160º arc
Extending the Stinger's close-in fighting capabilities, the claw mounted Breaker Blades have been retained. These weapons lance out to slash through enemies to either side and cut many foes down to size.
Hypercharged Alloy Tail Blades (x2) – Tail mounted, forward-to-rear arc via 180º elevation
The blades mounted on the Tyrann Stinger's tail are comprised of the same alloy as the claws, but they use the CPC armer system to charge them prior to every strike. With the momentum of the huge tail, the charged blades rip through enemies like tin foil..